Geomembrane using new technology to improve the anti-seepage effect: Geomembrane has excellent impact resistance, so even at -40F temperatures are so low at room temperature. Geomembrane polymer is non-toxic, tasteless, odorless white particles, the melting point of about 110 ℃ -130 ℃, the relative density of 0.918-0.965; has good heat resistance and cold. Good chemical stability, high rigidity and toughness practical PE geomembrane, good mechanical strength, resistance to environmental stress cracking resistance, tear strength and good performance, with increased density, mechanical properties and barrier properties will be a corresponding increase in resistance Hot PE geomembrane, and tensile strength is also higher; acid, alkali, organic solvents, such as corrosion. Shandong Hongxiang new materials low Geomembrane Geomembrane -HDPE cost-effective use of new technology to improve the anti-seepage effect, but the production process more scientific, speed Jie, so the product cost but lower than traditional waterproof material, the actual calculation general engineering use of HDPE impermeable membrane to cost savings of about 50% non-toxic environmentally friendly - impermeable membrane materials used are non-toxic and environmentally friendly materials HDPE geomembrane, seepage is a common principle of physical changes, does not produce any harmful substances 1. qualified acceptance by the appropriate civil documents before geomembrane. 2. Before cutting geomembrane should accurately measure its relative size PE geomembrane manufacturers, and then press the actual cutting, generally should not press the icon size cut specials PE geomembrane, should by piece number, a detailed record of the special form . 3. weld geomembrane should be sought at least, to ensure the quality of the premise, as far as possible to save raw materials. But also easy to ensure quality. 4. geomembrane seams between the membrane and the lap width is generally not less than 10cm, usually arranged in a direction parallel to the weld maximum slope that are arranged in the direction of the gradient. 5. At the corner and deformity usually lots should be to minimize the short length of the seam. In addition to special requirements, the slope is greater than 1: 6 slope within slope from the top or the stress concentration range of 1.5 m area, as no welds. Practical PE geomembrane, Edison new materials (certified), Zhejiang PE geomembrane provided by New Materials Co., Edison. Edison New Materials Co., Ltd. (www.fangshenmo.com) Shandong Texas, site construction materials leader, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs. New material in Edison led the staff warmly welcome all inquiries negotiations to create new materials Edison a better future.